Dumb hook-up question

maariv1
maariv1 Posts: 1
edited October 2005 in Basic Hookup/Wiring Questions
I have just bought wonderful polk audio monitor 30 speakers. Only problem is, that I cannot find in the user manual instructions regarding the two separate sockets that are found in the rear of each speaker. I have plugged the speakers to the receiver using one socket, but what do I do with the second one?

Thanks for helping!
Post edited by maariv1 on
· Share on FacebookShare on Twitter

Comments

  • aaharvel
    aaharvel Posts: 4,489
    edited October 2005
    Hi maariv! welcome to the forums!

    As long as the gold "jumpers" are in between both sets of binding posts- you are fine by just hooking the speakerwire to 1set. Either one is fine. If you remove the gold jumpers, then the top set represents the midrange driver and the bottom set represents the tweeter. Congratulations on your purchase and welcome!

    You'll find alot of information pertaining to your speakers AND to Polk Audio in general on these forums. Don't be a stranger.
    H/K Signature 2.1+235
    Jungson MagicBoat II
    Revel Performa M-20
    Velodyne cht-10 sub
    Rega P1 Turntable

    "People working at Polk Audio must sit around the office and just laugh their balls off reading many of these comments." -Lush
    · Share on FacebookShare on Twitter
  • reeltrouble1
    reeltrouble1 Posts: 9,312
    edited October 2005
    Please note that aaharvel is not telling you to remove the jumper. Leave it on, you might replace it someday with actual wire.

    RT1
    · Share on FacebookShare on Twitter