momo c300.2 amp

Systems
Systems Posts: 14,873
edited July 2005 in Car Audio & Electronics
i just polkmomo c300.2 amp. i am trying to connect it to a kicker comp vr sub., in with the amp bridged. i can get any sound to come out. with the everything connect

w
Testing
Testing
Testing
Post edited by Unknown User on
· Share on FacebookShare on Twitter

Comments

  • 1996blackmax
    1996blackmax Posts: 2,436
    edited July 2005
    Your statement was a little confusing. Are you getting any power to the amp?
    Alpine: CDA-7949
    Alpine: PXA-H600
    Alpine: CHA-S624, KCA-420i, KCA-410C
    Rainbow: CS 265 Profi Phase Plug / SL 165
    ARC Audio: 4150-XXK / 1500v1-XXK
    JL Audio: 10W6v2 (x2)
    KnuKonceptz
    Second Skin
    · Share on FacebookShare on Twitter
  • unrealii
    unrealii Posts: 268
    edited July 2005
    You are putting a 4 ohm load on the amp, right? The amp can't run 2 ohm in bridged mode.
    LSIm system on order =D

    Currently listening to innovation...

    Prior car systems:
    Nissan Maxima - Eclipse CD5030, Eclipse HDR109 HD Receiver, Eclipse PA5422, Eclipse PA5532, Polk SR 6500 (Front), Polk DB6510 (Rear), Image Dymanics IDQ10, active x-over setup
    Toyota MR2 - Eclipse CD5030, Eclipse HDR109 HD Receiver, Blaupunkt THA 555, Polk SR6500
    · Share on FacebookShare on Twitter
  • PolkThug
    PolkThug Posts: 7,532
    edited July 2005
    check fuse
    Never Forget
    · Share on FacebookShare on Twitter
  • neomagus00
    neomagus00 Posts: 3,899
    edited July 2005
    Originally posted by unrealii
    You are putting a 4 ohm load on the amp, right? The amp can't run 2 ohm in bridged mode.
    very true, it could be going into protect mode... just as a diagnostic, try hooking the sub up to only one channel, see if it works
    It's not good, very fundamentally simply not good. - geolemon

    "Its not good enough until we have real-time fearmongering. I want my fear mongered as it happens." - Shizelbs
    · Share on FacebookShare on Twitter