Digital Out with AMR-130

blown302
blown302 Posts: 2
edited April 2002 in Technical/Setup
I have a SBLive 5.1 on a kr7a-r, and I'm using the AMR-130 speakers, which I love BTW. But when I check the "digital output only" tab in the creative surround mixer, all I get is static. Anyone have any ideas?
Post edited by blown302 on
· Share on FacebookShare on Twitter

Comments

  • blown302
    blown302 Posts: 2
    edited March 2002
    Nobody? Somebodies gotta know something about this combo.
    Please!
    · Share on FacebookShare on Twitter
  • Dredge
    Dredge Posts: 1
    edited April 2002
    The digital out is used for if you are hooking up to a decoder, either Dolby Digital/ProLogic 1/2. Might be some speakers that can decode but they would probably brag that it has that support. You are using the analog signal which is straight audio, digital is compressed(zipped if you will) audio that needs to be decompressed before being heard. Your SBLive! 5.1 has a decoder in it(AC3=Dolby Digital) just in case you didn't know. :)
    · Share on FacebookShare on Twitter
  • joe logston
    joe logston Posts: 882
    edited April 2002
    wend you set to digital out on your sb-live this is for malti- digital speakers that haves its own da converter buit in to the speakers, if you dont have the digital speackers you wont get no sound
    . rt-7 mains
    rt-20p surounds
    cs-400i front center
    cs-350 ls rear center
    2 energy take 5, efects
    2- psw-650 , subs
    1- 15" audiosource sub

    lets all go to the next ces.
    · Share on FacebookShare on Twitter