Pop when turning off amp

newsman
newsman Posts: 203
edited March 2005 in Electronics
So recently I noticed that when I turn off my B&K 5ch amp, my speakers produce a soft pop sound. Is this normal?
Post edited by newsman on
· Share on FacebookShare on Twitter

Comments

  • McLoki
    McLoki Posts: 5,231
    edited March 2005
    Happens all the time when I turn off my Cinepro. I think the pop is independant of the volume control.

    It won't hurt anything,

    Michael
    Mains.............Polk LSi15 (Cherry)
    Center............Polk LSiC (Crossover upgraded)
    Surrounds.......Polk LSi7 (Gloss Black - wood sides removed and crossovers upgraded)
    Subwoofers.....SVS 25-31 CS+ and PC+ (both 20hz tune)
    Pre\Pro...........NAD T163 (Modded with LM4562 opamps)
    Amplifier.........Cinepro 3k6 (6-channel, 500wpc@4ohms)
    · Share on FacebookShare on Twitter
  • AsSiMiLaTeD
    AsSiMiLaTeD Posts: 11,728
    edited March 2005
    That amp is definitely JACKED...you should send it to me immediately...
    · Share on FacebookShare on Twitter
  • SDA SRS 1.2
    SDA SRS 1.2 Posts: 255
    edited March 2005
    My Sunfire does it too - just barely audible. The Carver TFM-45 never did it, though. :confused:

    Robbie
    Main System: Polk SDA SRS 1.2 Speakers, Sunfire Signature 600~two Amp, Carver C-16 Preamp, Carver TX-11b Tuner, Marantz 6350Q TT, Philips CDR-775 Recorder, Teac V-707RX Cassette Deck, Signal Cable Double Run Speaker Cable

    Upstairs Den: Marantz 2325 Receiver, Marantz 5220 Cassette Deck, Marantz HD-880 Speakers, Marantz 6370Q TT

    Exercise (Kabuki speaker) Room: Kenwood KR-9600 Receiver, Pioneer CS-99a Speakers, Sansui SP-X9000 Speakers (not pretty, but LOUD! :) )
    · Share on FacebookShare on Twitter