Connecting two PSW450s

vallibus
vallibus Posts: 2
edited February 2005 in Subwoofer Hookup & Bass Management
I'm looking to hook up two PSW450 subs to my system. Currently I have one PSW450 hooked up to my JVC RX-8030VBX's speaker connections (and the speakers are connected via the subwoofer.) What would be the preferred way to connect the second subwoofer? The receiver has connections for two sets of front speakers, and there are "pre-out" jacks for front, center, subwoofer, surround, and surround back speakers. Thanks in advance for any advice.

Bruce Wells
Post edited by vallibus on
· Share on FacebookShare on Twitter

Comments

  • gatemplin
    gatemplin Posts: 1,595
    edited February 2005
    Welcome to CP Bruce.

    There are a few ways to set them up. I prefer to use the sub preout. Split it with a ysplitter from radio shack etc. Run two coaxials to the subs. Then set up the bass management in the receiver. I would stack the subs too.
    Graham
    · Share on FacebookShare on Twitter
  • vallibus
    vallibus Posts: 2
    edited February 2005
    Graham,

    Thanks for the reply and suggestion. I've already bought my splitter and will follow your directions. Thanks again.

    Bruce
    · Share on FacebookShare on Twitter