Break in for LSi7

okiepolkie
okiepolkie Posts: 2,258
edited September 2004 in Basic Hookup/Wiring Questions
I have just received a new set of Polk LSi7s. I know they need to be broken in, but I am not sure how to do this correctly. Any help would be appreciated.

I am running them with a Yamaha rx-v2092.

Thanks.
Tschüss
Zach
· Share on FacebookShare on Twitter

Comments

  • F1nut
    F1nut Posts: 50,647
    edited September 2004
    Hook them up and play a constant source though them for at least 100 hours, then sit down to listen.
    Political Correctness'.........defined

    "A doctrine fostered by a delusional, illogical minority and rabidly promoted by an unscrupulous mainstream media, which holds forth the proposition that it is entirely possible to pick up a t-u-r-d by the clean end."

    President of Club Polk

    · Share on FacebookShare on Twitter
  • gmorris
    gmorris Posts: 1,179
    edited September 2004
    Just play them, forget about breaking them in. By simply using them as they are supposed to be used, they will break in all by themselves. There is no procedure or plan, per se.

    Enjoy...:)
    Bob Mayo, on the keyboards. Bob Mayo.
    · Share on FacebookShare on Twitter