C500.1 and MM120

Sisouphanh
Sisouphanh Posts: 1
edited July 2004 in Car Subwoofer Talk
I have 2 MM120's and 2 C500.1's I was wondering if I have to bridge them like a regular amp or if "sub 1" output was internally bridged already... the instructions say nothing about bridging... thanks.
Post edited by Sisouphanh on
· Share on FacebookShare on Twitter

Comments

  • bknauss
    bknauss Posts: 1,441
    edited July 2004
    The outputs are just in parallel and cannot be bridged. The second output is basically there so you can hook up two 4 ohm subwoofers and create a 2 ohm load as seen by the amp. Just use the sub 1 output on each amp to drive one MM12 (ie one amp per sub)
    Brian Knauss
    ex-Electrical Engineer for Polk
    · Share on FacebookShare on Twitter