Can I...

Systems
Systems Posts: 14,873
edited July 2004 in Car Audio & Electronics
Just wondering using the 400.4 amp and having mmc6500 in the front and mmc690 is there any way or should i say is it smart to run the 6500s @2ohms? and the 690s @4ohm at the same time?

thank you in advance to all your inputs.
Testing
Testing
Testing
Post edited by Unknown User on
· Share on FacebookShare on Twitter

Comments

  • MacLeod
    MacLeod Posts: 14,358
    edited June 2004
    No.

    The only way to get a 2 oohm load out of only 2 speakers is if they have 2 ohm voice coils or dual 4 ohm coils. I believe Image Dynamics makes some 2 ohm components. However the Polks are not so youre stuck with a 4 ohm load.

    You could run the front speakers bi-amped but this would put them over their power handling by quite a bit and Polk speakers dont react well to much more than their rated power.
    polkaudio sound quality competitor since 2005
    MECA SQ Rookie of the Year 06 ~ MECA State Champ 06,07,08,11 ~ MECA World Finals 2nd place 06,07,08,09
    08 Car Audio Nationals 1st ~ 07 N Georgia Nationals 1st ~ 06 Carl Casper Nationals 1st ~ USACi 05 Southeast AutumnFest 1st

    polkaudio SR6500 --- polkaudio MM1040 x2 -- Pioneer P99 -- Rockford Fosgate P1000X5D
    · Share on FacebookShare on Twitter
  • Systems
    Systems Posts: 14,873
    edited July 2004
    THANKS FOR THE INFO
    Testing
    Testing
    Testing
    · Share on FacebookShare on Twitter