Polk audio dx 10's
audiophileohms
Posts: 5
I have a pair of Polk dx 10's and they are in a box wired to their own binding posts , Can I run a jump from one set of binding posts to the other and still keep it at 4ohms or does that make it 2 ohm's?
Best Answer
-
audiophileohms wrote: »I am new here and I don't know how to navigate to the other thread where I asked the same question
Parallel makes them 2ohm
2-channel: Modwright KWI-200 Integrated, Dynaudio C1-II Signatures
Desktop rig: LSi7, Polk 110sub, Dayens Ampino amp, W4S DAC/pre, Sonos, JRiver
Gear on standby: Melody 101 tube pre, Unison Research Simply Italy Integrated
Gone to new homes: (Matt Polk's)Threshold Stasis SA12e monoblocks, Pass XA30.5 amp, Usher MD2 speakers, Dynaudio C4 platinum speakers, Modwright LS100 (voltz), Simaudio 780D DAC
erat interfectorem cesar et **** dictatorem dicere a
Answers
-
audiophileohms wrote: »I have a pair of Polk dx 10's and they are in a box wired to their own binding posts , Can I run a jump from one set of binding posts to the other and still keep it at 4ohms or does that make it 2 ohm's?
I responded to your last post in other thread
2-channel: Modwright KWI-200 Integrated, Dynaudio C1-II Signatures
Desktop rig: LSi7, Polk 110sub, Dayens Ampino amp, W4S DAC/pre, Sonos, JRiver
Gear on standby: Melody 101 tube pre, Unison Research Simply Italy Integrated
Gone to new homes: (Matt Polk's)Threshold Stasis SA12e monoblocks, Pass XA30.5 amp, Usher MD2 speakers, Dynaudio C4 platinum speakers, Modwright LS100 (voltz), Simaudio 780D DAC
erat interfectorem cesar et **** dictatorem dicere a -
I am new here and I don't know how to navigate to the other thread where I asked the same question
-
Thank you for answering my question, I appreciate you.