Like many, I assume - any Dreadnoughts available and for sale?
knie0012
Posts: 47
Kind of a shot in the dark:
Looking to purchase a 1000va dreadnought, but without a doubt, would purchase an 800va!
Thanks for your time!
Jason
Looking to purchase a 1000va dreadnought, but without a doubt, would purchase an 800va!
Thanks for your time!
Jason
Comments
-
If you can use a 625 va, I have one that I set up temporarily for the original SDA SRS. In my opinion it was excellent
sounding. It has the wiring for temp service until I found a box for it. I found a set of 1.2TL's and the project went to
the closet
/Users/jimcook/Pictures/Photos Library.photoslibrary/originals/A/AA3D3E56-F509-4249-B4CB-B9C8CA515BB2.jpeg
/Users/jimcook/Pictures/Photos Library.photoslibrary/resources/derivatives/E/E1E0C290-E1CD-4FF0-A661-B7F86463B630_1_105_c.jpeg -
They are $135 from parts express. I'll take $70 plus shipping if interested.
-
You used that for original SRS with a blade/blade socket?
-
I did. And I may have experimented with TL's. It's just been too long ago to recall for sure.
The SDA SRS was powered by a GFA7700 that did NOT like running without the grounds being jumped.
And things were great with the transformer too. Are you seeing the pin? -
No I seriously do not understand how you could use it on blade/blade interconnect where both blades carried signal, unlike a Pin/blade where only the pin carries a signal and the blade goes to ground. There is no "ground" on a Blade/blade cable that is why it MUST be used on common ground only.
-
Again my memory fails me. I'll need to reeducate myself on the purpose of the dreadnaught and its application.
It's been 15 years since. -
Okay I just want to make sure someone doesn't get the impression that it can be done.
Carry on -
My application would be for 2.3tl, P/B (now neutrik). One wire is a ground and the other wire carries the signal.
Thanks for stopping in!
-
Hi, me again! This post can also be closed. I was finally able to get an A.L Y236906 directly from them and built my own Dreadnought. Turned out perfect, I followed many posts here and Dynamated the entire inside and transformer, completely.
Thanks for the patience!
-
Nice job!
