Capacitor Layout for 5JR+
melchionda
Posts: 79
I'm about to start working on the new crossover for my Monitor 5 JR+ speakers. Here is the schematic.
It calls for a 13.5uf capacitor. To get to that value I got two 6.8uf capacitors. How do you connect them to get to that value? Am I supposed to wire them up in parallel or in series?
It calls for a 13.5uf capacitor. To get to that value I got two 6.8uf capacitors. How do you connect them to get to that value? Am I supposed to wire them up in parallel or in series?
Yamaha RX-A2080 HT Receiver in 5.4.4 configurationYamaha A-S2200 Integrated Amp Powering an extra set of Front SpeakersAudioLab 6000N Network Streamer Connected to Spotify and Amazon HD Music4 10" Subwoofers Powered By Dayton Audio 1200 DSP Amps4 In ceiling Atmos SpeakersSpeakers:Warfedale Diamond 9.1 (Front and Rear L+R)Polk Monitor 5 Jr+ (Front L+R)Martin Logan Motion SLM XL (Center Channel)Subwoofers 2x Dayton Audio RS270-8 10" Reference WooferSubwoofers 2x Dayton Audio RSS265HO-44 10" Reference Series HO DVC Subwoofer
Comments
-
Put one on top of the other, twist one of the two caps leads to the other caps leads fairly close to the body and solder to the lead. the other caps leads then go into the hole on the board.
-
