SDA 2B Blade Blade interconnect
warlocks1
Posts: 1,212
Just picked up a decent pair of Polk SDA 2B's with blade blade interconnect. I need a cable. I did a little research about making a interconnect, but I am still confused.
Can someone provide me directions on how to build or where to buy one.
The side panels are pulled away from the speaker, any specific glue I should use? Should I take the panels all the way off and scrape the dried glue or just re-glue?
I have been a long time member, but haven't been on in a long time.
Still own a set of 1.2TL's
Thanks,
Jeff
Can someone provide me directions on how to build or where to buy one.
The side panels are pulled away from the speaker, any specific glue I should use? Should I take the panels all the way off and scrape the dried glue or just re-glue?
I have been a long time member, but haven't been on in a long time.
Still own a set of 1.2TL's
Thanks,
Jeff
Comments
-
I believe Midwest sells the cable. Yes, remove the panels, clean up the old glue then use a construction adhesive. You'll need to clamp or weigh down the panels until the adhesive cures.Political Correctness'.........defined
"A doctrine fostered by a delusional, illogical minority and rabidly promoted by an unscrupulous mainstream media, which holds forth the proposition that it is entirely possible to pick up a t-u-r-d by the clean end."
President of Club Polk -
Thanks I'll take a look. Been a long time I remember listening to your SDA's. You played some Dead for me,
Hope all is well -
2B with blade/blade was somewhat unusual. Apparently, Polk was using leftover stock of connector bodies.
If that was me, I'd NOT buy a blade/blade SDA cable, I'd convert the speakers to a newer connector so that an isolation transformer and non-common-ground amplifiers could be used in the future.
-
This content has been removed.
