Karma: Pre-cut SDA 2 Dynamat Kit
spongebobsquarepants
Posts: 167
Just did Dynamat on my SDA-2A drivers, and had some left over. I figured I’d cut an extra set with the scrap, and see if anyone wants it. Enough pieces for SDA-2A or SDA-2B.
First person to post a picture of the speakers they’ll use it on can have the kit.
First person to post a picture of the speakers they’ll use it on can have the kit.
Comments
-
Very nice of you.
Political Correctness'.........defined
"A doctrine fostered by a delusional, illogical minority and rabidly promoted by an unscrupulous mainstream media, which holds forth the proposition that it is entirely possible to pick up a t-u-r-d by the clean end."
President of Club Polk -
Would they fit a set of CRS as well?
Nice Karma.Don't take experimental gene therapies from known eugenicists. -
You might need some trimming for the PR, but the drivers should be the same!
-
Surely someone will take these off your hands.Don't take experimental gene therapies from known eugenicists.
-
Pio Elete Pro 520
Panamax 5400-EX
Sunfire TGP 5
Micro Seiki DD-40 - Lyra-Dorian and Denon DL-160
PS Audio GCPH phono pre
Sunfire CG 200 X 5
Sunfire CG Sig 405 X 5
OPPO BDP-83 SE
SDA SRS 1.2TL Sonicaps and Mills
Ctr CS1000p
Sur - FX1000 x 4
SUB - SVS PB2-Plus
Workkout room:
Sony Bravia XBR- 32-Inch 1080p
Onkyo TX-DS898
GFA 555
Yamaha DVD-S1800BL/SACD
Ft - SDA 1C
Not being used:
RTi 38's -4
RT55i's - 2
RT25i's -2, using other 2 in shop
LSI 15's
CSi40
PSW 404 -
@vmaxer
Cool! I loved the change this made to the sound of my speakers, hopefully you will too!
Please PM me a shipping address
