Billet SDA-Neutrik Terminal Plates
xschop
Posts: 5,000
Material is aircraft grade 6061-T6, all CNC machined to accept Neutrik style terminals and any 1/2" diameter binding posts, as well as Cardas brand short posts. Will come loaded with all stainless Neutrik mount screws and stainless 8-32 enclosure mount screws with hurricane nuts for $112 shipped USPS PRIORITY INSURED...US-48 ONLY
Don't take experimental gene therapies from known eugenicists.
Comments
-
PurdyPolitical Correctness'.........defined
"A doctrine fostered by a delusional, illogical minority and rabidly promoted by an unscrupulous mainstream media, which holds forth the proposition that it is entirely possible to pick up a t-u-r-d by the clean end."
President of Club Polk -
Very very nice.
-
I will take a set of these.
-
Thanks Outlaw, I will get these out today with the nylon washers as well.
I only have 2 more sets on hand, just PM if interested.
Also I can add two more holes at 11 o'clock and 1 o'clock on request.Don't take experimental gene therapies from known eugenicists. -
All hooked up in my 1.2tl’s. For others Ace Hardware stocks a variety of nylon washers and spacers that make using the heavy duty Dayton terminals work great. I didn’t drill them for Bi-Wiring as I have 8’ 10awg wire feeding them. And I dont plan on Bi-Amping, I can always Add more terminals. Didn’t need to spend extra money on something I wasn’t going to use. Don’t forget get when ordering the neutrix connectors to get the gaskets. I also used rubber splicing tape for the gasket around the ring. Nice and flexible and works awesome.
-
Sending a set out to WMG. Only one set left for the next few weeks.Don't take experimental gene therapies from known eugenicists.
-
Scratch that. Looks Like these won't work on SDA-2A terminals.Don't take experimental gene therapies from known eugenicists.
-
-
I guess those terminals have crossover components mounted to cups. In reality they are easy to mod as they come apart with a little force as they are spot-glued around perimeter (Monitor ones I've dealt with anyway)
Don't take experimental gene therapies from known eugenicists. -
I guess those terminals have crossover components mounted to cups. In reality they are easy to mod as they come apart with a little force as they are spot-glued around perimeter (Monitor ones I've dealt with anyway)
Ok yes that is true. I thought maybe it was in reference to the blade/blade interconnect.
-
You can match the hole pattern and use threaded rod to mount the boards to the plate- Not Tom ::::::: Any system can play Diana Krall. Only the best can play Limp Bizkit.
-
I actually did a build where the stock cups mounted on the inside of the cut out and the plate on the outside, attached via threaded rod acorn nuts and nuts
- Not Tom ::::::: Any system can play Diana Krall. Only the best can play Limp Bizkit. -
I actually did a build where the stock cups mounted on the inside of the cut out and the plate on the outside, attached via threaded rod acorn nuts and nuts
Good thinking.Don't take experimental gene therapies from known eugenicists. -
I have one last set on hand to offer. It will be another 4-5 weeks before I start another run of these plates. Just PMDon't take experimental gene therapies from known eugenicists.
