MW 6600 Mid-Bass Drivers

Racfan9
Racfan9 Posts: 13
in Vintage Speakers
Hey Everyone...Was wondering if I could substitute a MW6600 Mid Driver in place of a MW 6500, and would the crossover's need re-worked? These are for the Monitor 10A's.

Racfan9
· Share on FacebookShare on Twitter

Comments

  • Racfan9
    Racfan9 Posts: 13
    bump
    · Share on FacebookShare on Twitter
  • pitdogg2
    pitdogg2 Posts: 25,440
    edited January 2019
    Polk to my knowledge has not released the specs on the MW6500 to my knowledge. I do know that the MW6600 and MW6501 share several of the same speakers and used the same XO to my knowledge. this is what they released on the MW6501.


    MW 6501 1.47 5.96 N 3.25 E - 3N/M 7.75 Ohms 31 Hertz


    My SDA1 signatures came from the factory with both MW6600 and MW6501 in the speakers. Later versions of the SDA1a came with all MW6501. Those speakers were considered a 4ohm load because of the way the drivers were configured in the speakers.

    hope this helps
    · Share on FacebookShare on Twitter
  • F1nut
    F1nut Posts: 50,543
    No
    Political Correctness'.........defined

    "A doctrine fostered by a delusional, illogical minority and rabidly promoted by an unscrupulous mainstream media, which holds forth the proposition that it is entirely possible to pick up a t-u-r-d by the clean end."

    President of Club Polk

    · Share on FacebookShare on Twitter
  • Racfan9
    Racfan9 Posts: 13
    Thanks pitdogg2.
    · Share on FacebookShare on Twitter