Parasound HCA 1200II - $400 (shipping and fees included)

cortico
cortico Posts: 587
edited January 2019 in For Sale (FS) Classifieds
Hi, I have a very clean 1200II for sale. Sounds really nice with any speaker I plugged into it.

Note:
-Speaker relays will need cleaning at some point, occasionally left Chanel drops off at very low volume, common issue and easy to resolve.

Sounds and looks great! I’ll pm more pics upon request.

Asking $400, item is located in Brooklyn, NY
pgwndxfdzq3q.jpeg
222zrnxrx7s5.jpeg

Comments

  • Mr. Sharpe
    Mr. Sharpe Posts: 1,354
    Such a nice amp! With the rack faceplate to??? And the matching preamp, cd and DAC? Shoot This shouldn’t last long at all! I’d be all over it for bridging if my speakers weren’t 4ohm crap it! Glws!!!
    Home theater:
    43” Westinghouse Displayer
    Marantz UD-7007 Player
    Emotiva MC-700 Processor
    Adcom GFA-5006 Amplifier
    Parasound Zamp Amplifier
    Ethereal ESO-1 Power Conditioner
    Klipsch RC-10 Center
    Klipsch R34c Fronts
    Klipsch RB-41 Surrounds
    Polk audio PSW-505

    Stereo:
    Polk audio RTA-12c’s fully upgraded crossovers
    DIY 12tc braided speaker cables
    Denon DVD-5910ci Spinner
    Parasound P6 Preamplifer
    Parasound HCA -1500a Amplifier
  • cortico
    cortico Posts: 587
    edited January 2019
    Correct, the other components are not included! The amp sounds beautiful.

    Cleaning the relays is an easy task, If you look at the open unit photo, they're located in the back of the unit, the 2 rectangular black boxes, for right and left channel.

    As I observed, this would be one way to do it:

    1- Remove top and bottom cover
    2- Disconnect grey signal cable plugs from left and right power amp to relay board.
    3- Release left and right ground black wires soldered to the star ground point in bottom of the unit.
    4- Unscrew back of the unit to access the speaker connector hex nuts (4) that old the board into place.

    5- With the board out will be easy to remove the relay caps clean. The best way to clean it too pass paper embedded with deoxit a few time between contacts.

    Amp off, off course! Do not use sand paper as this will screw up the contacts plating.

    New relays can be purchased from Parasound, inexpensive. Although, I think it's unnecessary.

    I hope this helps
    Post edited by cortico on
  • cortico
    cortico Posts: 587
    Lower price $325, plus shipping
    Thanks for looking!
  • deronb1
    deronb1 Posts: 5,021
    Great price! Great amp!
  • Mr. Sharpe
    Mr. Sharpe Posts: 1,354
    la2vegas wrote: »
    Mr. Sharpe wrote: »
    Such a nice amp! With the rack faceplate to??? And the matching preamp, cd and DAC? Shoot This shouldn’t last long at all! I’d be all over it for bridging if my speakers weren’t 4ohm crap it! Glws!!!

    I'm pretty sure that the other components are not included, or even offered for sale.

    I’m sorry, I just liked the picture because of the matching components, EXCUSE ME :s

    Home theater:
    43” Westinghouse Displayer
    Marantz UD-7007 Player
    Emotiva MC-700 Processor
    Adcom GFA-5006 Amplifier
    Parasound Zamp Amplifier
    Ethereal ESO-1 Power Conditioner
    Klipsch RC-10 Center
    Klipsch R34c Fronts
    Klipsch RB-41 Surrounds
    Polk audio PSW-505

    Stereo:
    Polk audio RTA-12c’s fully upgraded crossovers
    DIY 12tc braided speaker cables
    Denon DVD-5910ci Spinner
    Parasound P6 Preamplifer
    Parasound HCA -1500a Amplifier
  • Mr. Sharpe
    Mr. Sharpe Posts: 1,354
    cortico wrote: »
    Hi, I have a very clean 1200II for sale. Sounds really nice with any speaker I plugged into it.

    Note:
    -Speaker relays will need cleaning at some point, occasionally left Chanel drops off at very low volume, common issue and easy to resolve.

    Sounds and looks great! I’ll pm more pics upon request.

    Asking $400, item is located in Brooklyn, NY
    pgwndxfdzq3q.jpeg
    222zrnxrx7s5.jpeg

    I like your picture and setup

    Home theater:
    43” Westinghouse Displayer
    Marantz UD-7007 Player
    Emotiva MC-700 Processor
    Adcom GFA-5006 Amplifier
    Parasound Zamp Amplifier
    Ethereal ESO-1 Power Conditioner
    Klipsch RC-10 Center
    Klipsch R34c Fronts
    Klipsch RB-41 Surrounds
    Polk audio PSW-505

    Stereo:
    Polk audio RTA-12c’s fully upgraded crossovers
    DIY 12tc braided speaker cables
    Denon DVD-5910ci Spinner
    Parasound P6 Preamplifer
    Parasound HCA -1500a Amplifier
  • cortico
    cortico Posts: 587
    edited January 2019
    Mr. Sharpe wrote: »
    cortico wrote: »
    Hi, I have a very clean 1200II for sale. Sounds really nice with any speaker I plugged into it.

    Note:
    -Speaker relays will need cleaning at some point, occasionally left Chanel drops off at very low volume, common issue and easy to resolve.

    Sounds and looks great! I’ll pm more pics upon request.

    Asking $400, item is located in Brooklyn, NY
    pgwndxfdzq3q.jpeg
    222zrnxrx7s5.jpeg

    I like your picture and setup

    Thanks, just upgrade to the HCA 2200ii and PLD2000, killer setup
  • Mr. Sharpe
    Mr. Sharpe Posts: 1,354
    I’ve always loved the way their components matched. I’m very proud of my HCA-1500a and will probably always have it
    Home theater:
    43” Westinghouse Displayer
    Marantz UD-7007 Player
    Emotiva MC-700 Processor
    Adcom GFA-5006 Amplifier
    Parasound Zamp Amplifier
    Ethereal ESO-1 Power Conditioner
    Klipsch RC-10 Center
    Klipsch R34c Fronts
    Klipsch RB-41 Surrounds
    Polk audio PSW-505

    Stereo:
    Polk audio RTA-12c’s fully upgraded crossovers
    DIY 12tc braided speaker cables
    Denon DVD-5910ci Spinner
    Parasound P6 Preamplifer
    Parasound HCA -1500a Amplifier
  • cortico
    cortico Posts: 587
    Agreed, This amp sounds really good, it’s very pleasing to hear in general. I had it paired with the PHP850 preamp, which is another sweet deal, I what a sweet combo!

    It was a big improvement over my vintage Marantz rig, I was blown away with the way bigger width and depth of soundstage, the bass detail and definition is impressive.

    I got so hyped that I imidiatly chased the top of the line models...
  • cortico
    cortico Posts: 587
    This amp is still around, $325 shipped. It's a lot of amp for the price!
    Can't believe I am selling this for less than the Marantz 1060,
  • PM incoming
    Just a dude doing dude-ly things

    "Temptation is the manifestation of desire which equals necessity." - Mikey081057
    " I have always had a champange taste with a beer budget" - Rick88
    "Just because the thread is getting views don't mean much .. I like a good train wreck doesn't mean i want to be in one..." - pitdogg2
    "Those that don't know, don't know that they don't know." - heiney9
    "Audiophiles are the male equivalent of cat ladies." - Audiokarma Member
  • DavidinNC
    DavidinNC Posts: 1
    edited November 2019
    Is this still available?
  • what a deal. If not sold id be all over it.
  • cortico
    cortico Posts: 587
    This was sold about a year ago, good amp