SDA CRS+ and normal speakers at the same time?

Gretsch6136
Gretsch6136 Posts: 80
in Vintage Speakers
Hi all,

Just wondering if I connect my SDA's to Speaker output A (and use the interconnecting SDA cable) can I also run another set of normal speakers off the B output in another room?

Just a little concerned that the interconnecting cable might cause issues when running both sets at the same time. I don't want to risk blowing anything up!

The amp is a Denon PMA-715RG

Thanks,

Mark
· Share on FacebookShare on Twitter

Comments

  • F1nut
    F1nut Posts: 50,544
    Running SDA's off the A and another conventional pair off the B would not be an issue in itself, however the CRS+ is a nominal 6 ohm load. Your integrated is rated as follows, A+B: 8ohm-16ohm meaning the nominal load of both pairs should not be less than 8 ohms. I would advise not doing what you've inquired about.
    Political Correctness'.........defined

    "A doctrine fostered by a delusional, illogical minority and rabidly promoted by an unscrupulous mainstream media, which holds forth the proposition that it is entirely possible to pick up a t-u-r-d by the clean end."

    President of Club Polk

    · Share on FacebookShare on Twitter
  • Gretsch6136
    Gretsch6136 Posts: 80
    Thanks F1nut. I would rarely run them at the same time, and if so, at low volumes. Thanks for your input mate!
    · Share on FacebookShare on Twitter