My sub wont work with RX-A1040
afterburnt
Posts: 7,892
in Speakers
Comments
-
SVS PB1000???2-channel: Modwright KWI-200 Integrated, Dynaudio C1-II Signatures
Desktop rig: LSi7, Polk 110sub, Dayens Ampino amp, W4S DAC/pre, Sonos, JRiver
Gear on standby: Melody 101 tube pre, Unison Research Simply Italy Integrated
Gone to new homes: (Matt Polk's)Threshold Stasis SA12e monoblocks, Pass XA30.5 amp, Usher MD2 speakers, Dynaudio C4 platinum speakers, Modwright LS100 (voltz), Simaudio 780D DAC
erat interfectorem cesar et **** dictatorem dicere a -
probably operator error.
-
-
Got it to work with the Marantz, the Yamaha's fault
-
Kinda don't care, spare 2 channel and it werkz
-
-
Is the sub turned on in the menus of the Yamaha and the crossover points setup correctly with the mains set as small?afterburnt wrote: »They didn't speak a word of English, they were from South Carolina.
Village Idiot of Club Polk -
Is the sub turned on in the menus of the Yamaha and the crossover points setup correctly with the mains set as small?
Yup
-
It has not been run in a while but it was set up 5.1
-
Can I hook it up to one of the main pre outs without disconnecting the speaker or will I get that housafire that I asked for?
-
afterburnt wrote: »Can I hook it up to one of the main pre outs without disconnecting the speaker or will I get that housafire that I asked for?
for that you must check the manual. Some explicitly say no...Living Room 2.2: Usher BE-718 "tiny dancers"; Dual DIY Dayton audio RSS210HF-4 Subs with Dayton SPA-250 amps; Arcam SA30; Musical Fidelity A308; Sony UBP-x1000es
Game Room 5.1.4: Denon AVR-X4200w; Sony UBP-x700; Definitive Technology Power Monitor 900 mains, CLR-3000 center, StudioMonitor 350 surrounds, ProMonitor 800 atmos x4; Sub - Monoprice Monolith 15in THX Ultra
Bedroom 2.1 Harmon Kardon HK3490; Bluesounds Node N130; Polk RT25i; ACI Titan Subwoofer -
Did you switch out the sub cable?
Did you make sure the sub is on? (I have done this before...)
Did you make sure you are plugged into the SUB1 and not the SUB2 output on the yamaha?
Did you make sure the sub volume is turned up in the receiver?
Did you run YPAO and see if it senses a sub?Living Room 2.2: Usher BE-718 "tiny dancers"; Dual DIY Dayton audio RSS210HF-4 Subs with Dayton SPA-250 amps; Arcam SA30; Musical Fidelity A308; Sony UBP-x1000es
Game Room 5.1.4: Denon AVR-X4200w; Sony UBP-x700; Definitive Technology Power Monitor 900 mains, CLR-3000 center, StudioMonitor 350 surrounds, ProMonitor 800 atmos x4; Sub - Monoprice Monolith 15in THX Ultra
Bedroom 2.1 Harmon Kardon HK3490; Bluesounds Node N130; Polk RT25i; ACI Titan Subwoofer -
Damn it I am at fort Apache right now and don't have the stuff I need. I do have second sub and really short ICS on hand. Maybe a multimeter in my trunk
-
OIC said the blind man. All I had to do was put my face not the floor.
https://youtu.be/9pA2tXOjDto
