SRS 3.1 interconnect cable

aegis43

First day on the forum, so I already know I'm going to sound dumb and I apologize. I'm an audiofile noob. Can anyone point me to where I can get a new, or good used pin blade interconnect cable that is 30-feet, ish?

tonyb

Wow, 30 feet ? Not even gonna ask.

Try Douglas connections, he's a member here and sells speaker wire, he can probably hook you up.

aegis43

Thanks, Tony. I'll find him and ask.

pitdogg2

That pin blade end is going to be VERY HARD to find. Most here have converted to speakon's connection for that very reason. In the past some made use of RCA plugs that they trimmed off the outside gripper petals so the inner shaft could get deeper into the pin part. The blade part was not ever needed except for support of the cable, UNLESS you were using mono block type of amps then it served as the common ground part, from what I remember. The reason many moved away from the RCA was that in some cases it never made a good connection.
Doug may have something I cannot say so it is worth a try.

Good luck..

helipilotdoug

We don't have any of the pin blade connectors, so can't make copy of the original cable. We can make the speakon connector cable though.

trav0810

Is the blade even necessary? Until I got my Dreadnought, with new cables, my SDA cable was nothing more than a length of wire with RCA connectors with the outside connectors cut off of the RCA

pitdogg2

trav0810 wrote: »

Is the blade even necessary? Until I got my Dreadnought, with new cables, my SDA cable was nothing more than a length of wire with RCA connectors with the outside connectors cut off of the RCA

Correct on the blade Travis. Did you get a good tight fit with the RCA's