Nice Yamaha MX 2 150w/ch high current power amp
geppy1
Posts: 3,075
Selling 
my Yamaha MX2 power amp that is in excellent condition and works perfectly. The faceplate is real nice as is the top but there are a couple of light scratches on the top. The MX 2 was made 1992 to 1997 and was one of Yamaha's better efforts. It puts out 150 watts per channel into 8 ohms and 230 into 2 ohms. It can drive low impedance loads and has high dynamic output into 2 ohms. Specs below. The amp can drive 2 sets of speakers and has level controls on back. It is built like a tank and weighs over 40lbs. It also is very attractive and has a sleek look to it. I can ship at your cost and my packing is excellent. Asking just $350 Thanks
MX-2 Specification
Minimum RMS Output Power per Channel:
150 W (8 Ω) from 20 to 20,000 Hz at no more than 0,008% THD
190 W (4 Ω) from 20 to 20,000 Hz at no more than 0,03% THD
230 W (2 Ω) from 20 to 20,000 Hz at no more than 0,09% THD
Dynamic Power per Channel (by IHF Dynamic headroom Measuring Method):
190 W at 8 ohms
310 W at 6 ohms
410 W at 2 ohms
Dynamic Headroom :
1,03 dB at 8 ohms
2,12 dB at 6 ohms
2,51 dB at 2 ohms
Power Bandwidth (8Ω, 0,03% THD, half Rated Power): 10 to 60,000 Hz
Damping Factor
(SPA, 8Ω, 20 - 20,000 Hz) : 350
(8Ω, 1 kHz) : 250
Input Sensitivity/Impedance (Main IN): 1,26 V/20 kΩ
Frequency Response (Main In): 20 to 20,000 Hz, ±0,5 dB
Signal-to-Noise Ratio (IHF-A-Network): 123 dB (Main In, Shorted)
Residual Noise (IHF-A-Network): 20 μV
Channel Separation (Vol -30 dB, Main In, Input 5,1 kΩ terminaled)
1 kHz/10 kHz : 80 dB/ 60 dB
Dimensions (W x H x D): 438 x 116 x 486 mm (17-1/4 x 4-9/16 x 19-1/8 inch)
Weight: 19,5kg (43 lbs)
my Yamaha MX2 power amp that is in excellent condition and works perfectly. The faceplate is real nice as is the top but there are a couple of light scratches on the top. The MX 2 was made 1992 to 1997 and was one of Yamaha's better efforts. It puts out 150 watts per channel into 8 ohms and 230 into 2 ohms. It can drive low impedance loads and has high dynamic output into 2 ohms. Specs below. The amp can drive 2 sets of speakers and has level controls on back. It is built like a tank and weighs over 40lbs. It also is very attractive and has a sleek look to it. I can ship at your cost and my packing is excellent. Asking just $350 Thanks
MX-2 Specification
Minimum RMS Output Power per Channel:
150 W (8 Ω) from 20 to 20,000 Hz at no more than 0,008% THD
190 W (4 Ω) from 20 to 20,000 Hz at no more than 0,03% THD
230 W (2 Ω) from 20 to 20,000 Hz at no more than 0,09% THD
Dynamic Power per Channel (by IHF Dynamic headroom Measuring Method):
190 W at 8 ohms
310 W at 6 ohms
410 W at 2 ohms
Dynamic Headroom :
1,03 dB at 8 ohms
2,12 dB at 6 ohms
2,51 dB at 2 ohms
Power Bandwidth (8Ω, 0,03% THD, half Rated Power): 10 to 60,000 Hz
Damping Factor
(SPA, 8Ω, 20 - 20,000 Hz) : 350
(8Ω, 1 kHz) : 250
Input Sensitivity/Impedance (Main IN): 1,26 V/20 kΩ
Frequency Response (Main In): 20 to 20,000 Hz, ±0,5 dB
Signal-to-Noise Ratio (IHF-A-Network): 123 dB (Main In, Shorted)
Residual Noise (IHF-A-Network): 20 μV
Channel Separation (Vol -30 dB, Main In, Input 5,1 kΩ terminaled)
1 kHz/10 kHz : 80 dB/ 60 dB
Dimensions (W x H x D): 438 x 116 x 486 mm (17-1/4 x 4-9/16 x 19-1/8 inch)
Weight: 19,5kg (43 lbs)
Comments
-
Rear
-
SOLD