LSiC Parts

wetcoast

Long story short, I was testing out my Sunfire Signature Seven Grand after I had is checked out and the light replaced and I must have over driven my LSiC and damaged one of the mid-drivers. It's obviously damage the coil because it's not sounding very clear anymore and has a slight smokey aroma.

Can someone tell me where I can get some replacement drivers?

pitdogg2

open it up take a look at the crossover you more than likely fried one of the resistors. you may be able to replace that with a newer higher wattage resistor and be OK. If the resistor is say 5 watt replace it with a 10-12 watt resistor. I recommend mills resistors they have a very good reputation around here and very cheap but leaps better than the cement resistors Polk used.

wetcoast

pitdogg2 wrote: »

open it up take a look at the crossover you more than likely fried one of the resistors. you may be able to replace that with a newer higher wattage resistor and be OK. If the resistor is say 5 watt replace it with a 10-12 watt resistor. I recommend mills resistors they have a very good reputation around here and very cheap but leaps better than the cement resistors Polk used.

I manually manipulated the driver in and out and I can feel and hear the coil scratching. The coil on one mid driver is really toast. I will take a look at the crossover too while I have it apart.

pitdogg2

give Polk CS a call




9AM-5:30PM EST Mon-Fri

1.800.377.POLK (7655) Option 1

FAX: (410) 764-5470

polkcs@polkaudio.com

International: +1.410.358.3600