Dynaco up and running
leftwinger57
Posts: 2,917
I don't know if you guys knew that my $60 Dynaco Pat- s.s. pre/amp was shall we say quitting on me. One channel on the amp output port was putting out some static and cutting out but not entirely. Finally after using the Sony E2000ESD that Pumpkinman gifted me and said no, it's more of a surround processor than a pre/amp and was a pain to dial in I took another look at the Pat-4. I deoxit it both all knobs and controls and more importantly ran some through all the female RCA ports and it's ALL BETTER NOW. I still miss the remote but since I'm way more active now after the knee replacement I can get up and change sources. Whoohoo
2chl- Adcom GFA- 555-Onkyo P-3150v pre/amp- JVC-QL-A200 tt- Denon 1940 ci cdp- Adcom GFS-6 -Modded '87 SDA 2Bs - Dynamat Ext.- BH-5- X-Overs VR-3, RDO-194 tweeters, Larry's Rings, Speakon/Neutrik I/C- Cherry stain tops Advent Maestros,Ohm model E
H/T- Toshiba au40" flat- Yamaha RX- V665 avr- YSD-11 Dock- I-Pod- Klipsch #400HD Speaker set-
Bdrm- Nikko 6065 receiver- JBL -G-200s--Pioneer 305 headphones--Sony CE375-5 disc
H/T- Toshiba au40" flat- Yamaha RX- V665 avr- YSD-11 Dock- I-Pod- Klipsch #400HD Speaker set-
Bdrm- Nikko 6065 receiver- JBL -G-200s--Pioneer 305 headphones--Sony CE375-5 disc
Comments
-
Congrats on the fix.
Deoxit, the duct tape of the electronics world. -
Sometimes it's amazing what a little cleaning will do. I did the same with my PAS4 and while I'm not entirely sure it sounds better it does make me feel better
Yep, my name really is Bob.
Parasound HCA1500A(indoor sound) and HCA1000(outdoor sound), Dynaco PAS4, Denon DP1200 w/Shure V15 Type V and Jico SAS stylus, Marantz UD7007, Polk L600, Rythmik L12 sub. -
Have you tried the Deoxit on the knee?"Sometimes you have to look to the past to understand where you are going in the future"Harry / Marietta GA
