Polk Audio SDA SRS 2.3 Crossover Modification Thread

Options
VR3
VR3 Posts: 29,665
in DIY, Mods & Tweaks
I was able to get Jantzen to build a C-Coil this time, oh yes. I am shipping Sean one with his next build to complete his Abbot modification.

I made it to where the tweeter negative takes up one Molex entry and the inductor connection is routed through the main connection so the wiring is very clean.



g08dlbfivfbm.jpg
1c5yh181ott4.jpg
b0mb4aq67owc.jpg
- Not Tom ::::::: Any system can play Diana Krall. Only the best can play Limp Bizkit.
· Share on FacebookShare on Twitter

Comments

  • VR3
    VR3 Posts: 29,665
    Options
    Thank you :)
    - Not Tom ::::::: Any system can play Diana Krall. Only the best can play Limp Bizkit.
    · Share on FacebookShare on Twitter
  • honestaquarian
    honestaquarian Posts: 3,260
    Options
    Yeah what he^^ said
    · Share on FacebookShare on Twitter
  • VR3
    VR3 Posts: 29,665
    Options
    Thank you :)
    - Not Tom ::::::: Any system can play Diana Krall. Only the best can play Limp Bizkit.
    · Share on FacebookShare on Twitter
  • ptrooper
    ptrooper Posts: 514
    edited October 2016
    Options
    Around 350 hrs and its like a switch has been turned on to the 2.3's every fine detail surrounded by an enveloping midrange and a bottom end that sinks into darkness....This is what its all about.Thankyou Trey...Can't wait for the SRS Abbots to the theatre rears!
    · Share on FacebookShare on Twitter
  • Hergy
    Hergy Posts: 3
    Options
    I have the older 2.3 non TL’s that I have lost my crossover upgrade schematic. Already have all of my sonic caps and the bigger circuit board.installed my rings re-sealed my cabinets, epoxied all of my magnets, dyno matted all of the cages. Have the black hole just needs to be installed. But I lost those damn instructions on changing over to the updated crossovers and caps! Can anybody help a brother out?
    · Share on FacebookShare on Twitter