Dolby Atoms

I have 2 - 265RT as main fronts speakers / 255c RT as a Center channel / PSW505 subwoofer/ 2 - 65RT in ceiling above couch (listening area) / using a Denon AVR1200w receiver which has Dolby Atoms. Can I use the Dolby Atoms without needing more speakers? If no more speakers are necessary which speakers should I use as "Height Speakers"?

Thanks in advance!

Comments

  • F1nut
    F1nut Posts: 50,647
    It's Atmos.

    No.

    You don't have height speakers.

    Do you have a subwoofer?



    Political Correctness'.........defined

    "A doctrine fostered by a delusional, illogical minority and rabidly promoted by an unscrupulous mainstream media, which holds forth the proposition that it is entirely possible to pick up a t-u-r-d by the clean end."


    President of Club Polk

  • trj
    trj Posts: 320
    From what I read, you have 5.1 system. So, no atmos for you in the current configuration.

    For atmos, you need atleast 7 speakers(5.1.2 setup). If you purchase two more speakers and use them as side surrounds, you can use your in-ceiling speakers as atmos height channels.
    Sony BDP-S6500 | Raspberry Pi 2 | XBOX One S | Wii --> Yamaha RX-V667 --> Adcom 5006 bridged to 175 watts for front LCR -- >Front: Polk Audio RTi8s | Center: CSi5 | Side Surrounds: RTi4s | Rear surrounds: FXiA4s | Cheap 12" sub woofer|Samsung UN60KU6300
  • txcoastal1
    txcoastal1 Posts: 13,300
    For an Atmos in a 5.1.2 setup you would need to surround channels at approx ear height. You would move the ceiling speakers to the .2 position
    2-channel: Modwright KWI-200 Integrated, Dynaudio C1-II Signatures
    Desktop rig: LSi7, Polk 110sub, Dayens Ampino amp, W4S DAC/pre, Sonos, JRiver
    Gear on standby: Melody 101 tube pre, Unison Research Simply Italy Integrated
    Gone to new homes: (Matt Polk's)Threshold Stasis SA12e monoblocks, Pass XA30.5 amp, Usher MD2 speakers, Dynaudio C4 platinum speakers, Modwright LS100 (voltz), Simaudio 780D DAC

    erat interfectorem cesar et **** dictatorem dicere a