Please help, 3.1tl grill frame needed for resto-mod
gwg_97
Posts: 332
Working on a new project (3.1tl) and would love to find a replacement grill frame. The original frame was damaged by the previous owner (burned by a candle) and then snapped as I was attempting a repair. I just thought I would try before I am forced to make a new one.
Build thread to follow soon. Stay tuned.
Thanks!
Build thread to follow soon. Stay tuned.
Thanks!
System 1:Nakamichi PA-7Kenwood Basic C2Polk SDA 1C moddedSystem 2:Dynaco ST-70Polk Monitor 5B modded
Comments
-
I would definetly post this in Wanted section also. Someone might just have one. Good luck with your search..
-
Also couldn't hurt to call Polk CS worst they could say is nope.
-
Looks like I may have solved my problem with ome Titebond glue, clamps, and some bondo. I'll keep my fingers crossed.
System 1:Nakamichi PA-7Kenwood Basic C2Polk SDA 1C moddedSystem 2:Dynaco ST-70Polk Monitor 5B modded -
I have a similar problem, only I am missing the entire grills. Does anyone have a pattern for one? I can easily create a couple with a pattern.
-
This really sucks guys, I had a set of grills a few years ago, nobody wanted them, got tired of looking at them, and pitched them, along with a set of RTi8 grills, and a set of 15tl grills..
-
Toolfan66 - this should teach you a valuable lesson. Always keep every random grill no matter the condish just for us...even if it takes years for us to claim one.
Carver TX-11b - Carver 4000t - Carver TFM45 x2 - Polk SDA SRS 2 (094 tweets) - RSL CG 8^2 (Howard's XO upgrade + driver upgrade = 350w rms and amazeball toanz) -
DollarDave wrote: »I have a similar problem, only I am missing the entire grills. Does anyone have a pattern for one? I can easily create a couple with a pattern.
What do you need for a pattern? I can take some basic measurements if you want.
my 3.1TLs
I will fix your shifted magnets for free.
-
DollarDave wrote: »I have a similar problem, only I am missing the entire grills. Does anyone have a pattern for one? I can easily create a couple with a pattern.
What do you need for a pattern? I can take some basic measurements if you want.
Yep, that's all I need so I can cut two mirrored front grills.
-
Ok excellent I'll measure when I get home. If I still had a solidworks license I could make some dwgs for you, oh well. my 3.1TLs
I will fix your shifted magnets for free. -
46.5" tall x 15.25" wide
One cross bar: 14.625" from bottom to top of the one cross-bar
The rest is open except for a small boss on each side for a peg hole, each comes in 2.125" from side for a peg hole located 14" from the top
3/4" gussets at each intersection
Framing is 1.25" wide and 0.5" thick
That work? my 3.1TLs
I will fix your shifted magnets for free. -
Perfect!
