PSW10 question
Woundwort
Posts: 3
Hi!
I have a brand new PSW10 connected to a Yamaha RX-V479 receiver. The sub seemed to be working fine until I upgraded my front speakers to Polk Monitor 65T.
Now the sub doesn't seem to be used by the receiver. It doesn't come on when in "auto" mode and doesn't emit a sound when the text tone runs through all of the other speakers.
The sub does make a sound when the receiver is trying to configure all of the speakers.
Thanks in advance for your time! Any suggestions would be welcome.
I have a brand new PSW10 connected to a Yamaha RX-V479 receiver. The sub seemed to be working fine until I upgraded my front speakers to Polk Monitor 65T.
Now the sub doesn't seem to be used by the receiver. It doesn't come on when in "auto" mode and doesn't emit a sound when the text tone runs through all of the other speakers.
The sub does make a sound when the receiver is trying to configure all of the speakers.
Thanks in advance for your time! Any suggestions would be welcome.
Comments
-
Change all your speakers to "small" in the AVR manual setup menu.afterburnt wrote: »They didn't speak a word of English, they were from South Carolina.
Village Idiot of Club Polk -
I tried that and increased the crossover to 80, but there is no change. Thank you for the suggestion though!
-
Thanks fellows. I think you're right that it is a receiver issue. Thank you all for your time!
-
What are the optimal settings for my psw10 subwoofer. I am running a pair of Dyneaudio dm6 standmounts through a Nad 326bee intergrated amp.
