Using 7's as stands for CRS's?

elitt
elitt Posts: 162
in Vintage Speakers
Is this OK as a temporary solution while I wait for proper stands? It just occurred to me that the 7's are just about the right height, and the caution people would exercise around the set-up might help protect the CRSs which for now are way too low on my OEM 7 stands.

I'd isolate with solid rubber feet, and do not plan on a true 'stack' in that I won't run all 4 at once. The 7's would actually serve as non functioning stands.

Any issues to watch out for? Thank you for the help!
· Share on FacebookShare on Twitter

Comments

  • Toolfan66
    Toolfan66 Posts: 17,240
    No issues good fix till you get better stands... Enjoy!!
    · Share on FacebookShare on Twitter
  • elitt
    elitt Posts: 162
    Thank you.
    · Share on FacebookShare on Twitter
  • leftwinger57
    leftwinger57 Posts: 2,917
    I also temp changed my set up. My M7s were on iron slant stands originally made for JBL-2060s and while M5s might fit these 7s were a little to tipsy. So 52x6xozic4i7.jpg
    untill I get some nice wood stands that Mark Hardy and some others have right now they are on top of my ADC 303ax and again not so much into stacking but I had to get them out of the way.Those stands are now used for my EPI v100s and are a perfect fit
    2chl- Adcom GFA- 555-Onkyo P-3150v pre/amp- JVC-QL-A200 tt- Denon 1940 ci cdp- Adcom GFS-6 -Modded '87 SDA 2Bs - Dynamat Ext.- BH-5- X-Overs VR-3, RDO-194 tweeters, Larry's Rings, Speakon/Neutrik I/C- Cherry stain tops Advent Maestros,Ohm model E

    H/T- Toshiba au40" flat- Yamaha RX- V665 avr- YSD-11 Dock- I-Pod- Klipsch #400HD Speaker set-

    Bdrm- Nikko 6065 receiver- JBL -G-200s--Pioneer 305 headphones--Sony CE375-5 disc
    · Share on FacebookShare on Twitter