Onkyo DX C 909 drawer/belt issue

geppy1
geppy1 Posts: 3,075
in 2 Channel Audio
I have an Onkyo DX C 909 Integras 6 disc changer. that has an issue with the drawer not opening and closing on its own I can see a belt laying by a pulley but how do i get at it?? I would assume the drawer has to come out? Can anyone guide me on this? I would think Onkyo 6 disc units are the same drive wise?
Thanks

· Share on FacebookShare on Twitter

Comments

  • F1nut
    F1nut Posts: 50,554
    Open the top, the platter should be held in place by a single screw in the middle, remove it then the platter. You should have access to the belt at that point. That said, I've never worked on an Onkyo spinner, but can't imagine it would be all that different than the others.
    Political Correctness'.........defined

    "A doctrine fostered by a delusional, illogical minority and rabidly promoted by an unscrupulous mainstream media, which holds forth the proposition that it is entirely possible to pick up a t-u-r-d by the clean end."

    President of Club Polk

    · Share on FacebookShare on Twitter
  • geppy1
    geppy1 Posts: 3,075
    You would think so. Big circut board over half of it and a metal box under that. The thing is built like a tank and weighs 20lbs.
    · Share on FacebookShare on Twitter