Absolute Sound - CES high-end cables, power conditioners, and tweaks

I am a big, big fan of the audio improvements that clean power, good cables, and vibration elimination will produce when used with decent gear. I refer to it as the foundaton for your stereo.

This lists some of the new stuff at CES this year.

http://www.theabsolutesound.com/articles/ces-2015-high-performance-cables-power-products-and-system-tweaks/?utm_campaign=Newsletter&utm_medium=email&utm_source=email-335
Lumin X1 file player, Westminster Labs interconnect cable
Sony XA-5400ES SACD; Pass XP-22 pre; X600.5 amps
Magico S5 MKII Mcast Rose speakers; SPOD spikes

Shunyata Triton v3/Typhon QR on source, Denali 2000 (2) on amps
Shunyata Sigma XLR analog ICs, Sigma speaker cables
Shunyata Sigma HC (2), Sigma Analog, Sigma Digital, Z Anaconda (3) power cables

Mapleshade Samson V.3 four shelf solid maple rack, Micropoint brass footers
Three 20 amp circuits.

Comments

  • BlueFox
    BlueFox Posts: 15,251
    Yes, in my HT. My two-channel in living room is treated via furniture, carpet, and physical layout. It works quite well. Just last weekend, I removed the Auralex Acoustic foam I had installed on the wall behind the speakers. It helped with the Aerial Acoustics 7Ts, but appears detrimental with the Magico S5s. I also swapped out my listening chair from a recliner that put my ears slightly below the tweeter to a chair that put my ears slightly above the tweeter. This made a big difference in opening up the sound, and appeared to be a bit louder, and clearer. I will do some more experimenting this Friday and Saturday night with rearranging some furniture.
    Lumin X1 file player, Westminster Labs interconnect cable
    Sony XA-5400ES SACD; Pass XP-22 pre; X600.5 amps
    Magico S5 MKII Mcast Rose speakers; SPOD spikes

    Shunyata Triton v3/Typhon QR on source, Denali 2000 (2) on amps
    Shunyata Sigma XLR analog ICs, Sigma speaker cables
    Shunyata Sigma HC (2), Sigma Analog, Sigma Digital, Z Anaconda (3) power cables

    Mapleshade Samson V.3 four shelf solid maple rack, Micropoint brass footers
    Three 20 amp circuits.
  • mrbiron
    mrbiron Posts: 5,711
    Are you going to be moving your furniture sans alcohol...... :p
    Where’s the KABOOM?!?! There’s supposed to be an Earth shattering KABOOM!!!
  • BlueFox
    BlueFox Posts: 15,251
    Oh yes, but then the move needs to be evaluated with heightened senses for music. :)

    Seriously though, I have found that the sound is best after the amps have been on about 8 hours, and the night air has settled down. Usually this is around 11PM and later, and that occurs for me on Friday and Saturday night.
    Lumin X1 file player, Westminster Labs interconnect cable
    Sony XA-5400ES SACD; Pass XP-22 pre; X600.5 amps
    Magico S5 MKII Mcast Rose speakers; SPOD spikes

    Shunyata Triton v3/Typhon QR on source, Denali 2000 (2) on amps
    Shunyata Sigma XLR analog ICs, Sigma speaker cables
    Shunyata Sigma HC (2), Sigma Analog, Sigma Digital, Z Anaconda (3) power cables

    Mapleshade Samson V.3 four shelf solid maple rack, Micropoint brass footers
    Three 20 amp circuits.