wiring

jumper314
jumper314 Posts: 7
edited July 2014 in Basic Hookup/Wiring Questions
Hello everyone, I just purchased an Adcom GFA-555 power amplifier that I want to hook up to my Onkyo NR-717. If someone could tell me what would be the best way to wire it and what kind of wiring I need. I have Polk Audio RTiA9 speakers. I thank you for your time. Jumper314
Post edited by jumper314 on
· Share on FacebookShare on Twitter

Comments

  • F1nut
    F1nut Posts: 50,647
    edited July 2014
    I'll assume your AVR has pre-outs. So, you use RCA cables to connect from the pre-outs to the amp.
    Political Correctness'.........defined

    "A doctrine fostered by a delusional, illogical minority and rabidly promoted by an unscrupulous mainstream media, which holds forth the proposition that it is entirely possible to pick up a t-u-r-d by the clean end."

    President of Club Polk

    · Share on FacebookShare on Twitter
  • jumper314
    jumper314 Posts: 7
    edited July 2014
    Thank you very much.
    · Share on FacebookShare on Twitter
  • Glen B
    Glen B Posts: 269
    edited July 2014
    Make sure the amp is turned off before you connect/disconnect any cables.
    Main System: Denon DP-59L | Audio-Technica AT33EV | Marantz SA-11S2 | Classe DR-10 | Classe CA-300 | Classe RC-1 | PSB Stratus Gold i's | DIY Balanced AC Power Conditioner | Acoustic Zen and NeoTech cables | Oyaide and Furutech power connectors | Dedicated 20A isolated ground line.

    Home Theater: Toshiba D-VR5SU | Laptop #1 |Outlaw Audio OAW3 wireless audio system | Marantz SR-19 | Phase Linear 400 Series 2, modified | AudioSource 10.1 EQ (for subs) | Axiom M3 v3’s | Axiom VP150 | Optimus PRO-X55AVs | Dayton 12” powered subs (x2) | Belkin PureAV PF-60 line conditioner.

    Party System: Laptop #2 | Audioquest Dragonfly USB DAC | Technics SU-A6 | Acurus A-250 | Radio Shack 15-band EQ | Pioneer SR-9 reverb | Cerwin Vega DX9's | Dayton 100° x 60° horns with titanium HF/MF compression drivers.
    · Share on FacebookShare on Twitter