SDA wiring remake

Tucker_Z
Tucker_Z Posts: 21
edited June 2014 in Electronics
Would it be possible to completely remake the crossover network and such from the SDA series for a new remake of them? If so please provide moreinfo (such as circuit diagrams or whatever)
AVRs
Marantz SR-7400 - My room

Speakers
Polk RTA15TL - My room
Polk Monitor 5 - My room
Post edited by Tucker_Z on
· Share on FacebookShare on Twitter

Comments

  • ZLTFUL
    ZLTFUL Posts: 5,650
    edited June 2014
    All you needed to do was check out the stickies in the next sub-forum below this one.

    http://www.polkaudio.com/forums/showthread.php?55888-POLK-AUDIO-Speaker-Wiring-Schematics-amp-More-Stereo-Dimensional-Array%28SDA%29
    "Some people find it easier to be conceited rather than correct."

    "Unwad those panties and have a good time man. We're all here to help each other, no matter how it might appear." DSkip
    · Share on FacebookShare on Twitter
  • Tucker_Z
    Tucker_Z Posts: 21
    edited June 2014
    Which schematic should I use if I'm trying to build towers with 2 tweeters and 4 6½" mids and 2 subs?
    AVRs
    Marantz SR-7400 - My room

    Speakers
    Polk RTA15TL - My room
    Polk Monitor 5 - My room
    · Share on FacebookShare on Twitter
  • F1nut
    F1nut Posts: 50,566
    edited June 2014
    I'd suggest that if you want SDA's, you buy SDA's because it is obvious you have no idea what you're doing.
    Political Correctness'.........defined

    "A doctrine fostered by a delusional, illogical minority and rabidly promoted by an unscrupulous mainstream media, which holds forth the proposition that it is entirely possible to pick up a t-u-r-d by the clean end."

    President of Club Polk

    · Share on FacebookShare on Twitter
  • ZLTFUL
    ZLTFUL Posts: 5,650
    edited June 2014
    F1nut wrote: »
    I'd suggest that if you want SDA's, you buy SDA's because it is obvious you have no idea what you're doing.

    As F1nut stated, I'd suggest that if you want SDA's, you buy SDA's because it is obvious you have no idea what you're doing.

    If you did, you would know that the SDAs do not use an active sub-woofer but passive radiators.
    You would also know that reinventing the wheel is a bad idea.

    If you want to build speakers, there are much more cost effective options out there. The SDA crossovers are specced to work with specific drivers and in specifically design cabinets. Just throwing together a box with 4 drivers in it and putting an SDA crossover into it is going to result in nothing more than tears and heartache. :cry:
    "Some people find it easier to be conceited rather than correct."

    "Unwad those panties and have a good time man. We're all here to help each other, no matter how it might appear." DSkip
    · Share on FacebookShare on Twitter