Suggestions for Replacing Wire

Faustin
Faustin Posts: 1,149
edited May 2014 in Vintage Speakers
I am planning to upgrade the binding posts on several of my speakers and I want to replace the wires from the binding posts to the crossover board. I am looking for suggestions in regards to brand, gauge etc.
Post edited by Faustin on
· Share on FacebookShare on Twitter

Comments

  • drumminman
    drumminman Posts: 3,396
    edited May 2014
    Faustin wrote: »
    I am planning to upgrade the binding posts on several of my speakers and I want to replace the wires from the binding posts to the crossover board. I am looking for suggestions in regards to brand, gauge etc.

    Since it's such a short distanced why not splurge a little. One choice is Ohno continuous cast copper with Teflon insulation. You can possibly find it on ebay, or buy some here: http://www.vhaudio.com/wire.html . I've done business with VH Audio for years and can verify that they're a stand up company.
    "Science is suppose to explain observations not dismiss them as impossible" - Norm on AA; 2.3TL's w/sonicaps/mills/jantzen inductors, Gimpod's boards, Lg Solen SDA inductors, RD-0198's, MW's dynamatted, Armaflex speaker gaskets, H-nuts, brass spikes, Cardas CCGR BP's, upgraded IC Cable, Black Hole Damping Sheet strips, interior of cabinets sealed with Loctite Power Grab, AI-1 interface with 1000VA A-L transformer
    · Share on FacebookShare on Twitter
  • Faustin
    Faustin Posts: 1,149
    edited May 2014
    Thanks drumminman.
    · Share on FacebookShare on Twitter