amps to pre amp

tred2014
tred2014 Posts: 4
edited February 2014 in Basic Hookup/Wiring Questions
hi i am fairly new to component stereos and i need some input on what i want to do.i have 1 qsc usa 900 amp, 1 qsc mx1500a amp, and 1 museatex acc pre amp which has twin outputs [four].and 1 set cerwin vega d9 speakers and one set cerwin vega v 153 speakers.is it as simple as plugging one set of outputs from pre amp to one amp, and the same for the other, set the gains on the amps to match, connect two speakers to each amp and im ready to rock? thnx
Post edited by tred2014 on
· Share on FacebookShare on Twitter

Comments

  • spotty
    spotty Posts: 5
    edited January 2014
    I a word, Yes !
    · Share on FacebookShare on Twitter
  • tred2014
    tred2014 Posts: 4
    edited January 2014
    thank u both for your responses.nbrowser could u please go into some detail about your response so i can fully understand and maybe try to correct those issues? thnx
    · Share on FacebookShare on Twitter
  • F1nut
    F1nut Posts: 50,647
    edited January 2014
    Using pro gear and speakers that are not known for their sound quality is going to result in a lot of bad sound, IMO.

    Running 2 pair of stereo speakers together will cause soundwave cancellations, known as comb filtering and will result in even worse sound quality.
    Political Correctness'.........defined

    "A doctrine fostered by a delusional, illogical minority and rabidly promoted by an unscrupulous mainstream media, which holds forth the proposition that it is entirely possible to pick up a t-u-r-d by the clean end."

    President of Club Polk

    · Share on FacebookShare on Twitter
  • tonyb
    tonyb Posts: 32,981
    edited January 2014
    Especially 2 pair of speakers that aren't the same.
    HT SYSTEM-
    Sony 850c 4k
    Pioneer elite vhx 21
    Sony 4k BRP
    SVS SB-2000
    Polk Sig. 20's
    Polk FX500 surrounds

    Cables-
    Acoustic zen Satori speaker cables
    Acoustic zen Matrix 2 IC's
    Wireworld eclipse 7 ic's
    Audio metallurgy ga-o digital cable

    Kitchen

    Sonos zp90
    Grant Fidelity tube dac
    B&k 1420
    lsi 9's
    · Share on FacebookShare on Twitter
  • tred2014
    tred2014 Posts: 4
    edited January 2014
    ok i c thanks again for your input.i thought i read something about when using 4 speakers with the museatex acc pre amp, to install thr fourth speaker with reversed polarity at the speaker.could any one explain this so i can understand? thnx
    · Share on FacebookShare on Twitter
  • tred2014
    tred2014 Posts: 4
    edited February 2014
    also, just found out that quarter inch music plug for inputs on amp have neg tip as opposed to pos.also they are 3 wire and i assume rca on pre amp is 2 wire tip pos.one, can i get adapter that will change polarity at plud tip going into amp? and what about the fact quarter inch plug that goes to amp has ground? any input would b greatly appreciated thnx
    · Share on FacebookShare on Twitter