Polk Tsi 300
dcfaulcon
Posts: 2
I have some Polk TSI 300 and I am purchasing a Yaqin MC10l. The problem is that the Yaqin has banana plug connectors. I bought some pre made 12 gauge connectors from a site and they are too big to go into the Polk. Any advice on the proper gauge and connectors I should for these two would be greatly appreciated.
Post edited by dcfaulcon on
Comments
-
Both the Yaqin and the Polks have what are known as 5 way binding posts. You can use banana plugs, spades or bare wire, so I'm not sure what your issue is.Political Correctness'.........defined
"A doctrine fostered by a delusional, illogical minority and rabidly promoted by an unscrupulous mainstream media, which holds forth the proposition that it is entirely possible to pick up a t-u-r-d by the clean end."
President of Club Polk -
Betcha his issue is those darn plastic caps Polk puts over the binding post nuts. If your using banana connectors you need to pop off the plastic cap....not the nut, the plastic over the nut. Otherwise spades or bare wire will work fine with those plastic caps in place.HT SYSTEM-
Sony 850c 4k
Pioneer elite vhx 21
Sony 4k BRP
SVS SB-2000
Polk Sig. 20's
Polk FX500 surrounds
Cables-
Acoustic zen Satori speaker cables
Acoustic zen Matrix 2 IC's
Wireworld eclipse 7 ic's
Audio metallurgy ga-o digital cable
Kitchen
Sonos zp90
Grant Fidelity tube dac
B&k 1420
lsi 9's
