SRS side panels

tygr1955
tygr1955 Posts: 45
edited September 2013 in Vintage Speakers
Can I use Loctite Power Grab to reglue the side panels on my 2.3s? Should I use something else?
Post edited by tygr1955 on
· Share on FacebookShare on Twitter

Comments

  • F1nut
    F1nut Posts: 50,557
    edited September 2013
    Yes.
    Political Correctness'.........defined

    "A doctrine fostered by a delusional, illogical minority and rabidly promoted by an unscrupulous mainstream media, which holds forth the proposition that it is entirely possible to pick up a t-u-r-d by the clean end."

    President of Club Polk

    · Share on FacebookShare on Twitter
  • heartystatue
    heartystatue Posts: 329
    edited September 2013
    I used it to reglue the inside edges all the way around with the speakers removed. Are you talking about reattaching one of the whole sides?
    HT: LSI15, LSIC, LSIFX, Emo XPA-3:biggrin: Onkyo TXNR809, Sony BDP-S500, PannyDMP-BDT320, MIT S1 SC. Mit 73842dlp
    2ch: SDA-SRS 2.3 Fully modded. BAT VK500 w/batpak, BAT VK5I, Essence HDACC.
    · Share on FacebookShare on Twitter
  • tygr1955
    tygr1955 Posts: 45
    edited September 2013
    heartystatue wrote: »
    I used it to reglue the inside edges all the way around with the speakers removed. Are you talking about reattaching one of the whole sides?

    No just a couple of loose ends.
    · Share on FacebookShare on Twitter