DSW pro 660 problems with automatic on/off

Slawo
Slawo Posts: 1
edited September 2013 in Subwoofer Hookup & Bass Management
Hi,
I'm having problem to activate subwoofer if set for automatic on /off. Doesn't senses audio and not switching on or
switching to standby after 10 min of work
All OK if power switch set to standby position and activated manually by remote control.
Any idea what can be wrong?
Thanks for any tips
Post edited by Slawo on
· Share on FacebookShare on Twitter

Comments

  • [Deleted User]
    [Deleted User] Posts: 7,658
    edited September 2013
    Hello Slawo,
    Welcome to Polk's forum. One of the more common causes is that the selector switch on Polk's subwoofers is a three position switch. Usually the middle position is the "auto" on/off selection. Sometimes it can be a little tricky to get the switch in the correct position.
    If this doesn't help check with Polk's CS department at: polkcs@polkaudio.com or telephone to: 1-800-377-7655.
    Regards, Ken
    · Share on FacebookShare on Twitter
  • Thorton
    Thorton Posts: 1,324
    edited September 2013
    Slawo,

    Welcome to Club Polk. Ken's suggestion is good. Also, I've found that the sub will only activate at about med-low to med volume in the automatic on mode. Good Luck.
    _____________________________________________________________________________________________
    Ethernet Filter: GigaFOILv4 with Keces P3 LPS
    Source: Roon via ethernet to DAC interface
    DAC: Bricasti M1SE
    Pre/Pro: Marantz AV8805
    Tube Preamp Buffer: Tortuga TPB.V1
    Amp1: Nord One NC1200DM Signature, Amp2: W4S MC-5, AMP3: W4S MMC-7
    Front: Salk SoundScape 8's, Center: Salk SoundScape C7
    Surround: Polk FXIA6, Surround Back: Polk RTIA9, Atmos: Polk 70-RT
    Subs: 2 - Rythmik F25's
    IC & Speaker Cables: Acoustic Zen, Wireworld, Signal Cable
    Power Cables: Acoustic Zen, Wireworld, PS Audio
    Room Treatments: GIK Acoustics
    · Share on FacebookShare on Twitter