PSW650 (new) lost power

rschwarzkopf
rschwarzkopf Posts: 1
edited July 2001 in Technical/Setup
After setting up my new PSW650 it appeared to be working fine for about 15 minutes. It quit as I was gently adjusting its location about 12 inches. I suspect it is a fuse or circuit breaker. Where would it be located? Is this speaker really this sensitive?
Post edited by rschwarzkopf on
· Share on FacebookShare on Twitter

Comments

  • mjmcg
    mjmcg Posts: 102
    edited July 2001
    You say it quit while moving it about 12"?...measure the power cord, if it comes up 11", move the sub back approx. 1". I'm of course being smart, you'll have to wiat until Ken helps you on this one.
    · Share on FacebookShare on Twitter
  • BobMcG
    BobMcG Posts: 1,585
    edited July 2001
    ...for Ken. He'll straighten things out.

    In the meantime, ... you didn't trip the mercury "tilt" circuit in the unit, did you? :D
    · Share on FacebookShare on Twitter