Beginner needing some HELP

moby63
moby63 Posts: 2
edited July 2013 in Speakers
I want upgrade my speaker system from SVS SBS-01 Speaker System

http://www.hometheater.com/content/svs-sbs-01-speaker-system-and-pioneer-vsx-1017txv-k-av-receiver-glance-ratings-svs

to

rti a7 or rti a9 and CSI A6

Onkyo TX-NR818
OPPO BDP-93
Sharp AQUOS LC-80LE844U

Thx for help
Post edited by moby63 on

Comments

  • BlueFox
    BlueFox Posts: 15,251
    edited June 2013
    Sure. Go ahead. Glad to help. :smile:
    Lumin X1 file player, Westminster Labs interconnect cable
    Sony XA-5400ES SACD; Pass XP-22 pre; X600.5 amps
    Magico S5 MKII Mcast Rose speakers; SPOD spikes

    Shunyata Triton v3/Typhon QR on source, Denali 2000 (2) on amps
    Shunyata Sigma XLR analog ICs, Sigma speaker cables
    Shunyata Sigma HC (2), Sigma Analog, Sigma Digital, Z Anaconda (3) power cables

    Mapleshade Samson V.3 four shelf solid maple rack, Micropoint brass footers
    Three 20 amp circuits.
  • heartystatue
    heartystatue Posts: 329
    edited June 2013
    Welcome to CP. If you do some reading around here that question has been brought up quite a bit. From what I have read either way you should add a sub especially if your using strictly for HT. Either way, going the polk route is an upgrade. Good luck.
    HT: LSI15, LSIC, LSIFX, Emo XPA-3:biggrin: Onkyo TXNR809, Sony BDP-S500, PannyDMP-BDT320, MIT S1 SC. Mit 73842dlp
    2ch: SDA-SRS 2.3 Fully modded. BAT VK500 w/batpak, BAT VK5I, Essence HDACC.
  • theshawn
    theshawn Posts: 70
    edited July 2013
    Going the Polk route is an upgrade from what? Other mass marketed speakers? :cheesygrin:
  • F1nut
    F1nut Posts: 50,828
    edited July 2013
    The RTi A9's need a power amp to drive them. The RTi A7's will work much better with your AVR.
    Political Correctness'.........defined

    "A doctrine fostered by a delusional, illogical minority and rabidly promoted by an unscrupulous mainstream media, which holds forth the proposition that it is entirely possible to pick up a t-u-r-d by the clean end."


    President of Club Polk

  • moby63
    moby63 Posts: 2
    edited July 2013
    I just ordered the rti a9 and the csi a 6 and xpa 3 I will keep my sub svs PB10-NSD and the sbs 02 for the rear channels
    some settings tips will help
    thanks