Subwoofer connection problem.

polkyaudio
polkyaudio Posts: 2
edited June 2013 in Subwoofer Hookup & Bass Management
I just bought the Polk RM6750 system.

I purchased a subwoofer audio pin cable for the subwoofer as instructed. However, when I plug it into the back of my
receiver yamaha rx-v373, it doesn't go in very far and easily falls out. What is the precise cable I should buy?

Also, where does the other end of the audio pin cable go into on the subwoofer? There appears to "R" and "L".
Should i purchase a splitter? If so, precisely which one?


thanks
Post edited by polkyaudio on
· Share on FacebookShare on Twitter

Comments

  • zane77
    zane77 Posts: 1,696
    edited June 2013
    I am not familiar with the RM 6750 system, but the subwoofer on most systems use a standard RCA connector and cable and connect it to the red subwoofer input.
    Home Theater
    Onkyo PR-SC5508 Sharp LC-70LE847U
    Emotiva XPA-5 Emotiva XPA-2 Emotiva UPA-2
    Front RTi-A9 Wide RTi-A7 Center CSi-A6 Surround FXi-A6 Rear RTi-A3 Sub 2x PSW505
    Sony BDP-S790 Dishnetwork Hopper/Joey Logitech Harmony One Apple TV
    Two Channel
    Oppo 105D BAT VK-500 w/BatPack SDA SRS 2.3 Dreadnought Squeezebox Touch Apple TV
    · Share on FacebookShare on Twitter
  • polkyaudio
    polkyaudio Posts: 2
    edited June 2013
    I just figured it out. I had to press more firmly to get the cord to fit appropriately. Sounds awesome now!
    · Share on FacebookShare on Twitter