Bi wire help

Jhayman
Jhayman Posts: 1,548
edited June 2013 in Basic Hookup/Wiring Questions
Just got my MIT TERMINATOR 2 bi wire cables from George, I've never bi wired before is it each set of ends to each full terminal or am I going one on top of the other, the complete opposite of normal 2 wire..
My speaker posts are side by side with jumpers connected..
+ -
J J
+ -

Does itvmattervif the blue side is on top going to tweeters or does it need to go low?
ATC SCM40's,VTL TL 2.5 Preamp,PSB Stratus Goldi's,McCormack DNA 500,McCormack MAP-1 Preamp,Pro-Ject Xtension 10 TT,Ortofon Cadenza Red/Nordost RedDawn LS Speaker cables, Bryston BDP-2, Bryston BDA-2,PS Audio AC-3 power cables
· Share on FacebookShare on Twitter

Comments

  • F1nut
    F1nut Posts: 50,649
    edited June 2013
    Remove the jumpers. One set of leads are marked high output, they go to the top posts. Red is +, blue is -. The other set of leads are marked low output, they go to the bottom posts. Red is +, blue is -.
    Political Correctness'.........defined

    "A doctrine fostered by a delusional, illogical minority and rabidly promoted by an unscrupulous mainstream media, which holds forth the proposition that it is entirely possible to pick up a t-u-r-d by the clean end."

    President of Club Polk

    · Share on FacebookShare on Twitter
  • Jhayman
    Jhayman Posts: 1,548
    edited June 2013
    Thank You vey kindly..:razz:
    ATC SCM40's,VTL TL 2.5 Preamp,PSB Stratus Goldi's,McCormack DNA 500,McCormack MAP-1 Preamp,Pro-Ject Xtension 10 TT,Ortofon Cadenza Red/Nordost RedDawn LS Speaker cables, Bryston BDP-2, Bryston BDA-2,PS Audio AC-3 power cables
    · Share on FacebookShare on Twitter