Safeguards for speaker "amp pops"?
Options
Today I was jamming out a bit and the main house power went for for like 1 second but enough to reset my components. I had it loud but not cranked way up. When the amp reset all music stopped and there was a loud pop sent to my speakers. Luckily they seem fine but would like to find a way to protect them from things like that. I could put a ups on the amp and other components but curious of other or better ways.
---
Polk Studio Monitor 4.6 Series 2's, Polk RT1000p's, Polk LSi25's, Boston Acoustic VR-975's
Crown D-75, Crown CE1000, Crown CE2000
Polk Studio Monitor 4.6 Series 2's, Polk RT1000p's, Polk LSi25's, Boston Acoustic VR-975's
Crown D-75, Crown CE1000, Crown CE2000
Post edited by KellyMic on
Comments
-
As soon as the power flickered, I would have unplugged the system until everything stabilized. I do not have a UPS, but my power filtering does do voltage correction and would have caught that issue, but unplugging is ALWAYS your best option if you're concerned.
-
Most people are not quick enough to get it switched off.
Most power filters can only maintain voltage for a small fraction of a second.
Putting everything but the power amps on a UPS is a good plan.
Especially units that have hard drives or possessor (DSP) chips or DC supply's that don't shut-down/restart politely. -
As soon as the power flickered, I would have unplugged the system until everything stabilized. I do not have a UPS, but my power filtering does do voltage correction and would have caught that issue, but unplugging is ALWAYS your best option if you're concerned.
The power was only out for about 1 second, had no time to react. Wasn't an actual outage.---
Polk Studio Monitor 4.6 Series 2's, Polk RT1000p's, Polk LSi25's, Boston Acoustic VR-975's
Crown D-75, Crown CE1000, Crown CE2000