Template for Larry's ring for CRS+ binding post cup. Anyone have one?
nspindel
Posts: 5,343
Larry had a pair of rings I was able to grab off him for the binding post cups on the CRS+'s, but he doesn't have any templates for it. Anyone happen to have one that they can loan to me? I can probably make due without and be close enough, but if someone has one lying around after already completing the install, I'd love to get my hands on it.
Good music, a good source, and good power can make SDA's sing. Tubes make them dance.
Post edited by nspindel on
Comments
-
Why not use the binding post cup itself? Turn it around and place it on a piece of paper, mark the outline of the cup and the screw holes, tape the piece of paper in place on the back of the cabinet, drill."Science is suppose to explain observations not dismiss them as impossible" - Norm on AA; 2.3TL's w/sonicaps/mills/jantzen inductors, Gimpod's boards, Lg Solen SDA inductors, RD-0198's, MW's dynamatted, Armaflex speaker gaskets, H-nuts, brass spikes, Cardas CCGR BP's, upgraded IC Cable, Black Hole Damping Sheet strips, interior of cabinets sealed with Loctite Power Grab, AI-1 interface with 1000VA A-L transformer
-
Well, don't even need to use the cup, I could trace the four posts on the ring on a piece of paper. But nothing beats having a steel template clamped down, so there is zero error due to the drill bit wandering, etc. If I can't find one of the templates, I'm fully intending on making due, but if someone has one lying around, I'd prefer to use it.Good music, a good source, and good power can make SDA's sing. Tubes make them dance.
