PA660 Speaker Harness Help

chrisnguyen550`
chrisnguyen550` Posts: 3
edited July 2012 in Car Audio & Electronics
The amplifier has a Speaker Level Harness ( Converts OEM Speaker Wire to Amp)
i have 4 OEM speaker wire ran to the trunk but the Harness need 6 speaker wires.
ANY Suggestion please?
Post edited by chrisnguyen550` on

Comments

  • nguyendot
    nguyendot Posts: 3,594
    edited July 2012
    Read the manual? Page 8 and 9. Also the harness needs 8 wires or 4pairs. Manual here:http://www.polkaudio.com/downloads/manual/PAampDXi_MN.pdf
    Main Surround -
    Epson 8350 Projector/ Elite Screens 120" / Pioneer Elite SC-35 / Sunfire Signature / Focal Chorus 716s / Focal Chorus CC / Polk MC80 / Polk PSW150 sub

    Bedroom - Sharp Aquos 70" 650 / Pioneer SC-1222k / Polk RT-55 / Polk CS-250

    Den - Rotel RSP-1068 / Threshold CAS-2 / Boston VR-M60 / BDP-05FD
  • chrisnguyen550`
    chrisnguyen550` Posts: 3
    edited July 2012
    my bad. i know you need 8 not 6.
    but i connected 4 speaker wire to LR,LF, and RR,RF
    amp turn on only if i blast up my volume
    and i have two stock speakers in front and aftermarket in the back will t-tapping the two front affect the
    power output?
  • chrisnguyen550`
    chrisnguyen550` Posts: 3
    edited July 2012
    any help guys only got 2 pairs of stock speaker running to the back
    but you need 4 pairs
  • MacLeod
    MacLeod Posts: 14,358
    edited July 2012
    What's the problem? If its the amp not turning on, you can run the turn on wire to a small fuse that comes on only with the ignition. I've had to do this a few times and always used the radio fuse.
    polkaudio sound quality competitor since 2005
    MECA SQ Rookie of the Year 06 ~ MECA State Champ 06,07,08,11 ~ MECA World Finals 2nd place 06,07,08,09
    08 Car Audio Nationals 1st ~ 07 N Georgia Nationals 1st ~ 06 Carl Casper Nationals 1st ~ USACi 05 Southeast AutumnFest 1st

    polkaudio SR6500 --- polkaudio MM1040 x2 -- Pioneer P99 -- Rockford Fosgate P1000X5D