SDA 2.3 Crossover Problems

Gill3896 · 2012-07-13 14:25:21

One of the coils on the crossover board got hot and melted it's plastic. I have checked all the resistors and caps on the board with a meter and the Schematic and they are ok. I need to replace this coil (.4mH) I don't have much to go on as far as specs (type, pwr rating). Could use a replacement crossover if anyone has…

Comments

F1nut Posts: 50,561

September 2012 edited September 2012

Gill3896 wrote: »

don't have a good local electronics store. Any advice?

Yes you do, Vintage HiFi of Pittsburgh.

Political Correctness'.........defined

"A doctrine fostered by a delusional, illogical minority and rabidly promoted by an unscrupulous mainstream media, which holds forth the proposition that it is entirely possible to pick up a t-u-r-d by the clean end."

President of Club Polk

0 · Share on Facebook Share on Twitter