New face!

lanchile
lanchile Posts: 560
edited April 2012 in DIY, Mods & Tweaks
My new face for my diy integrated amp! 3M metal sandpaper works wonderfully with aluminum! all done by hand.
Make it simple...Make it better!
Post edited by lanchile on
· Share on FacebookShare on Twitter

Comments

  • lanchile
    lanchile Posts: 560
    edited April 2012
    This is the circuitry for the LED's lights that I used. They are connected right after power switch.
    value of resistor will affect the brightness of led's
    Make it simple...Make it better!
    · Share on FacebookShare on Twitter
  • lanchile
    lanchile Posts: 560
    edited April 2012
    Last one!
    Make it simple...Make it better!
    · Share on FacebookShare on Twitter
  • drumminman
    drumminman Posts: 3,396
    edited April 2012
    Looks very nice! Good job. Are you planning to clear coat it to keep it looking new?
    "Science is suppose to explain observations not dismiss them as impossible" - Norm on AA; 2.3TL's w/sonicaps/mills/jantzen inductors, Gimpod's boards, Lg Solen SDA inductors, RD-0198's, MW's dynamatted, Armaflex speaker gaskets, H-nuts, brass spikes, Cardas CCGR BP's, upgraded IC Cable, Black Hole Damping Sheet strips, interior of cabinets sealed with Loctite Power Grab, AI-1 interface with 1000VA A-L transformer
    · Share on FacebookShare on Twitter
  • lanchile
    lanchile Posts: 560
    edited April 2012
    drumminman wrote: »
    Looks very nice! Good job. Are you planning to clear coat it to keep it looking new?
    Good idea! Thanks. I will clean it very well with alcohol and then I will put two coats of polyurethane.
    Make it simple...Make it better!
    · Share on FacebookShare on Twitter