psw505

jmadrox2010
jmadrox2010 Posts: 1
edited March 2012 in Subwoofer Hookup & Bass Management
how do i hook up 2 psw505's and how should i place them so they dont sound out of phase?
Post edited by jmadrox2010 on
· Share on FacebookShare on Twitter

Comments

  • tommyt21
    tommyt21 Posts: 685
    edited March 2012
    If you have a sigle sub line out (.1) Then I would run a sub cable over to a stacked set facing the same direction connecting the two with Y splitter.

    If you have .2 LFE then you could seperate them but thats a little more difficult in terms of calibration and placement.

    PS do you already own 2 PSW505's? If not I would look at getting a single High Quality sub instead. My HSU will smoke 2 PSW505's in my opinion. The advantage of two subs is typically higher db and if their spread out better coverage of room nulls (bass holes). In your case 2 PSW505's still are not going to help get tighter, deeper, cleaner bass. Honestly it will just make the bass louder.

    All in my opinion. Some of the smarter guys should chime in.:redface:
    Living Room
    Fronts: RTi A7's
    Center: Csi A6 VR3 "Fortress Plus"
    Front Heights: Rti A1
    Surrounds: Rti A3
    Sub: HSU VTF-2 MK4 Damn this is a good SUB
    Pioneer Pioneer Elite: SC-35-> Emotiva XPA-3
    TV: Lg LW6500 55" Passive 3D
    Blu-Ray Panasonic BD 210
    XboX 360 Slim/Kinect

    Acoustimac red suede panels
    · Share on FacebookShare on Twitter