WIMA MKP4 Capacitors As Power Bypass - Preamp

PreCd
PreCd Posts: 786
edited December 2011 in DIY, Mods & Tweaks
I have a Adcom GFP-565 that I have replaced all the capacitors in save the bypass caps in the power supply stage. Currently they have WIMA 4.7uf 100v MKC caps there for bypass. The WIMA site says the sub for those are WIMA MKPs. Only problem is that the lead spacing is not 30mm but is 37mm for that value of MKP4.

Any suggestions on which cap I should use in the power stage for bypass if I cannot use the MKP4?
SDA2BTL
Marantz CD5004
Adcom GFA-545
Bottlehead Quickie Tube Preamp
· Share on FacebookShare on Twitter

Comments

  • F1nut
    F1nut Posts: 50,654
    edited December 2011
    Just bend the leads in a bit.
    Political Correctness'.........defined

    "A doctrine fostered by a delusional, illogical minority and rabidly promoted by an unscrupulous mainstream media, which holds forth the proposition that it is entirely possible to pick up a t-u-r-d by the clean end."

    President of Club Polk

    · Share on FacebookShare on Twitter