New to Home Theatre but need some help

abaca
abaca Posts: 5
edited December 2011 in Basic Hookup/Wiring Questions
(Home Theater)
Hello,

I just purchased my system and I spent most of the night getting things connected. I have a question about my blu-ray player going through my receiver. I did a quick set up and have not had the time to trouble-shoot yet but I have a pop up on my tv that says HDMII>Not supported mode. My Sat/Cable is also through my receiver and it works fine. Does anyone know if i need to change a setting with my blu-ray or with my receiver? I am going from my blu-ray out to the receiver then out from there to my tv. I am currently looking for my manuals on my tv and blu-ray.

Thanks.

Here is my system:
Onkyo TX-NR509
Sony BDP-S570 Blu ray
Polk RM95
Polk PSW110
Samsung 55" HDTV(don't know model)
5.1 Set-up
Post edited by abaca on
· Share on FacebookShare on Twitter

Comments

  • chumlie
    chumlie Posts: 8,658
    edited December 2011
    Adjust the tv settings.
    · Share on FacebookShare on Twitter
  • jbooker82
    jbooker82 Posts: 1,627
    edited December 2011
    Mine lg doenst do that but the lg logo will pop up like its not getting any HDMI signal for a second or two.
    AVR: Onkyo Tx-NR808
    Amplifier: Carver A-753x 250 watts x 3
    Fronts: Polk RTI A7 (modded by Trey VR3)
    Center: CSI A4 (modded by Trey VR3)
    Rear: FXI A4
    Sub: Polk DSW Pro 660wi
    TV: LG Infinia 50PX950 3D
    Speaker Cable: AudioQuest Type 8
    IC: AudioQuest Black Mamba II
    · Share on FacebookShare on Twitter