Internal wiring SDA-CRS+

audiocr381ve
audiocr381ve Posts: 2,588
edited November 2011 in Vintage Speakers
Hey fellas, I seem to have misplaced some of my internal wiring in my CRS+'s, mainly the wire from the crossover to the MW drivers. I was wondering if Canare 4S11 14-gauge cable would be acceptable to use.

Thanks dudes
Post edited by audiocr381ve on
· Share on FacebookShare on Twitter

Comments

  • drumminman
    drumminman Posts: 3,396
    edited November 2011
    audiocr381ve wrote: »
    Hey fellas, I seem to have misplaced some of my internal wiring in my CRS+'s, mainly the wire from the crossover to the MW drivers. I was wondering if Canare 4S11 14-gauge cable would be acceptable to use.

    Thanks dudes

    If it was me I'd try mil spec silver plated teflon coated stranded copper, avail on ebay or through surplus dealers. Cheap and many have had good results.
    "Science is suppose to explain observations not dismiss them as impossible" - Norm on AA; 2.3TL's w/sonicaps/mills/jantzen inductors, Gimpod's boards, Lg Solen SDA inductors, RD-0198's, MW's dynamatted, Armaflex speaker gaskets, H-nuts, brass spikes, Cardas CCGR BP's, upgraded IC Cable, Black Hole Damping Sheet strips, interior of cabinets sealed with Loctite Power Grab, AI-1 interface with 1000VA A-L transformer
    · Share on FacebookShare on Twitter
  • Face
    Face Posts: 14,340
    edited November 2011
    That would work fine. Be sure to either use quick disconnects or tin the leads well before soldering them to the drivers.
    "He who fights with monsters should look to it that he himself does not become a monster. And when you gaze long into an abyss the abyss also gazes into you." Friedrich Nietzsche
    · Share on FacebookShare on Twitter
  • audiocr381ve
    audiocr381ve Posts: 2,588
    edited November 2011
    Got it, thanks guys.
    · Share on FacebookShare on Twitter
  • quadzilla
    quadzilla Posts: 1,543
    edited November 2011
    Don't know. My results with silver plated copper have been... not good. I hear a nasty harshness/hash in every bit I've tried that isn't there when using either pure silver or pure copper.
    Turntable: Empire 208
    Arm: Rega 300
    Cart: Shelter 501 III
    Phono Pre: Aural Thrills
    Digital: Pioneer DV-79ai
    Pre: Conrad Johnson ET3 SE
    Amp: Conrad Johnson Evolution 2000
    Cables: Cardas Neutral Reference
    Speakers: SDA 2.3TL, heavily modified
    · Share on FacebookShare on Twitter