Infinity RS-IIIa crossovers
halo71
Posts: 4,603
I bought these a little while back. Always wanted a big pair of old Infinity's. From the get go they just didn't seem to have the sound I thought they should, lack of bass etc. Well today I pulled the XO plates and here is what I found.
What a mess....
Something has came apart! lol
This is what the other one looks like.
Money is TIGHT! Are these speakers worth updating the crossovers? Cheapest route possible? I noticed the woofers seem to be wired correct. Any suggestions on lack of bass? Maybe I am expecting too much from them?
What a mess....
Something has came apart! lol
This is what the other one looks like.
Money is TIGHT! Are these speakers worth updating the crossovers? Cheapest route possible? I noticed the woofers seem to be wired correct. Any suggestions on lack of bass? Maybe I am expecting too much from them?
--Gary--
Onkyo Integra M504, Bottlehead Foreplay III, Denon SACD, Thiel CS2.3, NHT VT-2, VT-3 and Evolution T6, Infinity RSIIIa, SDA1C and a few dozen other speakers around the house I change in and out.
Onkyo Integra M504, Bottlehead Foreplay III, Denon SACD, Thiel CS2.3, NHT VT-2, VT-3 and Evolution T6, Infinity RSIIIa, SDA1C and a few dozen other speakers around the house I change in and out.
Post edited by halo71 on
Comments
-
Did one of the caps explode? It seriously looks as though the small electrolytic on the black board exploded?
-
In the last pic, the silver cap that is parallel to the magnet wrapped thingy, that is connected to the big crusty pot. That is the cap that came apart. Don't think it happened since I bought them though.--Gary--
Onkyo Integra M504, Bottlehead Foreplay III, Denon SACD, Thiel CS2.3, NHT VT-2, VT-3 and Evolution T6, Infinity RSIIIa, SDA1C and a few dozen other speakers around the house I change in and out.
